Workstation table made for Trimpro trimmers

Description

Workstation for Trimpro Trimmers

With this table for the Trimpro Original, you will totally change the way your trimmer works. Before, you had to pass the branches over it while it took off the leaves.

With this table, you should separate the buds from the branches, then put a considerable amount on the table, and you will have to give them plenty of turn with your hand as if you were mixing bingo balls, until they are left with no leaves.

How to use Trimpro Workstation Table

• Separate buds from the branches.
• Place them on top of the table.
• Move them around by hand until all leaves detach.
• All the leftover leaf trim ends up in a cloth bag depository that comes with the table.
• Afterwards, leaves can be used for doing hashish extraction, using 0% Impurity Colibri Gas For BHO.

Made of long-lasting stainless steel

Very safe to use, but we still recommend gloves to avoid any dangerous and unnecessary accidents when trimming.

It is quite easy to clean, and if you want to scrape it off the resin, be sure to use a wooden utensil, because if you use something metallic and scratch the surface, you will remove the non-stick surface and much more resin will end up sticking to these areas in the future.

This machine has several security systems to cut the electrical current if the top is open while it is in operation.

Convert your Trimpro Original in a Workstation, reducing the amount of work you will have to do.

Made of highly resistant steel.