Find answers in our
Build your franchise
We help you set up your store
Contact with our
User atention center
Get rid of the odors in your crop before they get out to the street, with Uvonair CD-1000 with 2 crowns. It will eliminate the strongest scents of your plantation.
By installing an Uvonair CD-1000 US-2 crown ozonizer in the air extraction duct, you will be able to eliminate all the odors of your plants before they come out.
Ozone destroys all sorts of mites, bacteria, fungi and particles that form odors by oxidizing the surfaces it gets in contact with. Due to its oxidizing power, it must not travel down your extractor nor your bulb and, in general, through no electrical device. Place you ozonizer after all devices. If you do not have a cooltube, place it behind the extractor. If you do, or have a cooled reflector, you will have to instal the ozonizer after the reflector.
After installing it, there should be a minimal length of 5m of duct so it can take effect and work properly, mixing the air with the ozone completely. The air will reach the street pure and free of odors. It is more than advisable, to install an odor filter to prevent dust from building up. However, it will not be necessary to replace the filter, just make sure the filter sleeve is clean so that it can retain dust properly.
This ozonizer generates 3,000mg/h which is enough to clean an extraction flow rate of 1,500m3/h while destroying the strongest scent at the end of flowering. It could support up to 3,000m3/h but the complete elimination of odor is not guaranteed unless it has an active coal anti-odor filter. The device only consumes 60w and the inlet diameter is 250mm.
These ozonizers are not in stock and are ordered upon request, taking up to 48h hours for us to ship.