Complete UNIS Co2 Evolution Controller DONE

Complete UNIS CO2 Evolution Controller to Monitor your Plants

The UNIS controller by Evolution is perfect for keeping the Co2 in your grow room under control. You can simply input the size of your grow room and the controller will take care of the electrovalve, depending on the needed levels.

When using a CO2 regulator you can open or close your CO2 bottles when needed, avoiding unnecessary usage; a complete kit to get you started using Co2 in to grow your cannabis.

This kit is perfect for beginner CO2 growers

Now, we’ll briefly explain how it works so you can start using your UNIS controller. First, connect the regulator to the CO2 bottle and check that the fiber ring is in place before tightening up the connection to the bottle. Then, connect the UNIS controller plug to the regulator, checking the rubber ring is in place. Now, attach the plug to the regulator using the internal attachment screw. Finally, you can plug the controller into the mains.

Recommendations:

• Make sure the unit is always unplugged before connecting the fan and/or the unit’s heater.
• Always check that all cables and wires have been properly connected and that the cover has been safely screwed back in place before plugging the unit into the mains.
• Remember that combining water and electricity is very dangerous. Electricity can be fatal, especially in the presence of water.
• We highly recommend the installation of electrical appliances, in grow spaces, above floor level, on a shelf or attached to the walls, to avoid contact with water in case there’s a leak or an accidental spill.